Volkswagen Golf 8 GTI Golf R 2.0 TSI ECU Engine Control Unit - Genuine OEM 06K907425N

Replace a faulty or damaged engine computer with this Genuine OEM Volkswagen Engine Control Unit, part number 06K907425N.

This electronic control module is designed for selected Volkswagen Golf 8 GTI and Golf R vehicles equipped with a compatible 2.0 TSI petrol engine and SIMOS 19.6 engine-management system.

The ECU controls essential engine functions, including fuel injection, ignition timing, turbocharger operation, emissions systems, sensor information and communication with other vehicle control modules.

Product Features

• Genuine OEM Volkswagen engine-management component
• Volkswagen part number 06K907425N
• Alternative part number format 06K 907 425 N
• Selected units may carry the extended number 06K907425N5H0
• Petrol engine control unit or engine control module
• Associated with selected SIMOS 19.6 systems
• Suitable for selected Volkswagen Golf 8 GTI models
• Suitable for selected Volkswagen Golf 8 R models
• Designed for compatible 2.0 TSI engine configurations
• Original factory housing and electrical connections

Common Symptoms of a Faulty ECU

• Engine does not start or starts intermittently
• Engine warning or EPC light remains illuminated
• Loss of power or reduced-performance mode
• Fuel-injection, ignition or turbocharger-control faults
• Communication faults with the engine control module
• Multiple engine-management fault codes
• Internal electronic, moisture or corrosion damage

Vehicle Compatibility

This ECU may be suitable for selected Volkswagen Golf 8 GTI and Golf R vehicles equipped with a compatible 2.0 TSI petrol engine.

Compatibility depends on the vehicle production date, engine code, transmission type, emissions equipment, complete part-number suffix, hardware number and software version.

Please compare every number on the replacement ECU with the original module before purchasing. Similar-looking control units may contain different software and should not be considered interchangeable solely because their housings and connectors appear identical.

Coding and Programming Requirements

Coding, programming or professional ECU cloning is normally required when installing this engine control module into another vehicle.

A standard replacement ECU may require immobiliser adaptation, VIN and security-data matching, vehicle-specific software programming, online control-module coding and diagnostic fault-code clearing before the engine will start and operate correctly.

If the original ECU data is professionally cloned onto a compatible replacement unit, separate immobiliser adaptation may not be required. An unmatched new, remanufactured or used ECU should not be considered plug-and-play.

Installation Information

Professional installation by a Volkswagen technician or qualified automotive electronics specialist is strongly recommended.

The vehicle should be diagnostically tested before replacing the ECU to confirm that the module is responsible for the fault. Power supplies, earth connections, wiring, sensors and communication networks should also be inspected.

After installation, the ECU should be programmed correctly and the vehicle should be scanned and tested to verify communication with the immobiliser, transmission, emissions and engine-management systems.